M25P80-VMN6TP Electronic IC Chips Flash memory with 75 MHz SPI bus interface
electronic integrated circuit
,linear integrated circuits
M25P80
8 Mbit, low voltage, serial Flash memory with 75 MHz SPI bus interface
Features
■ SPI bus compatible serial interface
■ 75 MHz Clock rate (maximum)
■ 2.7 V to 3.6 V single supply voltage
■ 8 Mbit of Flash memory
■ Page Program (up to 256 bytes) in 0.64 ms (typical)
■ Sector Erase (512 Kbit) in 0.6 s (typical)
■ Bulk Erase (8 Mbit) in 8 s (typical)
■ Hardware Write protection: protected area size defined by three non-volatile bits (BP0, BP1 and BP2)
■ Deep Power-down mode 1 µA (typical)
■ Electronic signatures
– JEDEC Standard two-byte signature (2014h)
– Unique ID code (UID) +16 bytes of CFI data
– RES instruction one-byte signature (13h) for backward compatibility
■ More than 100 000 Program/Erase cycles per sector
■ More than 20 years’ data retention
■ Packages
– ECOPACK® (RoHS compliant)
Description
The M25P80 is an 8 Mbit (1 Mbit × 8) Serial Flash memory, with advanced write protection mechanisms, accessed by a high speed SPI-compatible bus.
The memory can be programmed 1 to 256 bytes at a time, using the Page Program instruction.
The memory is organized as 16 sectors, each containing 256 pages. Each page is 256 bytes wide. Thus, the whole memory can be viewed as consisting of 4096 pages, or 1,048,576 bytes.
The whole memory can be erased using the Bulk Erase instruction, or a sector at a time, using the Sector Erase instruction.
In order to meet environmental requirements, Numonyx offers the M25P80 in ECOPACK® packages. ECOPACK® packages are Lead-free and RoHS compliant.
Maximum rating
Stressing the device above the rating listed in the absolute maximum ratings table may cause permanent damage to the device. These are stress ratings only and operation of the device at these or any other conditions above those indicated in the operating sections of this specification is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability. Refer also to the Numonyx SURE Program and other relevant quality documents.
| Symbol | Parameter | Min. | Max. | Unit |
|---|---|---|---|---|
| TSTG | Storage Temperature | –65 | 150 | °C |
| TLEAD | Lead Temperature during Soldering | (1) | °C | |
| VIO | Input and Output Voltage (with respect to Ground) | –0.6 | VCC + 0.6 | V |
| VCC | Supply Voltage | –0.6 | 4.0 | V |
| VESD | Electrostatic Discharge Voltage (Human Body model) (2) | –2000 | 2000 | V |
Note:
1. Compliant with JEDEC Std J-STD-020C (for small body, Sn-Pb or Pb assembly), the Numonyx ECOPACK® 7191395 specification, and the European directive on Restrictions on Hazardous Substances (RoHS) 2002/95/EU.
2. JEDEC Std JESD22-A114A (C1=100 pF, R1=1500 Ω, R2=500 Ω)
Stock Offer (Hot Sell)
| Part no. | Quantity | Brand | D/C | Package |
| PCA9532PW | 12140 | 15+ | TSSOP | |
| AZ75232GTR-E1 | 1052 | BCD | 11+ | TSSOP20 |
| CS6422-CSZR | 1453 | CIRRUS | 14+ | SOP |
| Z85C3008PSC | 450 | ZILOG | 06+ | DIP-40 |
| LT6700CS6-3#TRPBF | 14614 | LINEAR | 15+ | SOT |
| MC34164D-3R2G | 3472 | ON | 10+ | SOP |
| 34992* | 2102 | BOSCH | 15+ | ZIP-15 |
| 30651 | 907 | BOSCH | 11+ | QFP-64 |
| PIC16F873A-I/SO | 4903 | MICROCHIP | 16+ | SOP |
| LT3980EMSE | 5605 | LT | 13+ | MSOP |
| MC74HC4538AN | 4782 | ON | 10+ | DIP |
| MMSZ4680T1 | 20000 | ON | 10+ | SOD-123 |
| MAX232DR | 30000 | TI | 16+ | SOP |
| MAX232CSE | 30000 | MAXIM | 16+ | SOP |
| MAX232ECPWR | 8150 | TI | 15+ | TSSOP |
| CLRC66301HN | 1178 | 13+ | QFN32 | |
| N82S23AN | 3650 | PHILIPS | 14+ | DIP |
| MMA8453QT | 4412 | FREESCALE | 13+ | QFN |
| MC56F8013VFAE | 3580 | FREESCALE | 16+ | QFP |
| MBR1100 | 25000 | ON | 16+ | DO-41 |
| QG82945GSE SLB2R | 300 | INTEL | 09+ | BGA |
| MC44603AP | 3532 | ON | 10+ | DIP |
| LTC2262CUJ-14 | 638 | LINEAR | 15+ | QFN |
| MBRF2545CTG | 17618 | ON | 11+ | TO-220 |
| MCP9803T-M/SN | 5716 | MICROCHIP | 14+ | SOIC |
| L5973ADTR | 3873 | ST | 15+ | SOP8 |
| MJD50T4G | 38000 | ON | 16+ | SOT-252 |
| PIC18F2620-I/SP | 4513 | MICROCHIP | 10+ | DIP |
| PC716V | 11580 | SHARP | 16+ | DIP |
| LTC4355IMS | 6363 | LINEAR | 15+ | MSOP |
W25N01GVZEIG SLC Nand Flash Memory IC 3V 1G BIT Winbond TW SPI
PF48F4400P0VBQEK NEW AND ORIGINAL STOCK
DSPIC30F3011-30I/PT Flash Memory IC NEW AND ORIGINAL STOCK
IR2110PBF NEW AND ORIGINAL STOCK
S25FL032P0XMFI010 SOP8 104MHz Flash Memory IC Chip
W25Q80DVSNIG Serial Flash Chip 3V 8M BIT Dual Quad Spi Memory Integrated Circuit
MOS Tube Field Effect Single-Chip Drive PWM Controlador Module IRF520
MAX485, RS485 Module TTL To RS-485 Module TTL To 485
SKY65336-11 NEW AND ORIGINAL STOCK
| Image | Part # | Description | |
|---|---|---|---|
|
|
W25N01GVZEIG SLC Nand Flash Memory IC 3V 1G BIT Winbond TW SPI |
FLASH - NAND (SLC) Memory IC 1Gbit SPI - Quad I/O 104 MHz 7 ns 8-WSON (8x6)
|
|
|
|
PF48F4400P0VBQEK NEW AND ORIGINAL STOCK |
FLASH - NOR (MLC) Memory IC 512Mbit CFI 52 MHz 110 ns 64-LBGA (11x13)
|
|
|
|
DSPIC30F3011-30I/PT Flash Memory IC NEW AND ORIGINAL STOCK |
dsPIC dsPIC™ 30F Microcontroller IC 16-Bit 30 MIPs 24KB (8K x 24) FLASH 44-TQFP (10x10)
|
|
|
|
IR2110PBF NEW AND ORIGINAL STOCK |
Half-Bridge Gate Driver IC Non-Inverting 14-DIP
|
|
|
|
S25FL032P0XMFI010 SOP8 104MHz Flash Memory IC Chip |
FLASH - NOR Memory IC 32Mbit SPI - Quad I/O 104 MHz 8-SOIC
|
|
|
|
W25Q80DVSNIG Serial Flash Chip 3V 8M BIT Dual Quad Spi Memory Integrated Circuit |
FLASH - NOR Memory IC 8Mbit SPI - Quad I/O 104 MHz 8-SOIC
|
|
|
|
MOS Tube Field Effect Single-Chip Drive PWM Controlador Module IRF520 |
N-Channel 100 V 9.2A (Tc) 60W (Tc) Through Hole TO-220AB
|
|
|
|
MAX485, RS485 Module TTL To RS-485 Module TTL To 485 |
1/1 Transceiver Half RS422, RS485 8-uMAX/uSOP
|
|
|
|
SKY65336-11 NEW AND ORIGINAL STOCK |
RF Front End 2.4GHz ISM 28-MCM (8x8)
|