Send Message
Home > products > Amplifier IC Chips > ERA-3SM+ Integrated Circuit Chip MONOLITHIC AMPLIFIERS 50з BROADBAND DC to 8 GHz

ERA-3SM+ Integrated Circuit Chip MONOLITHIC AMPLIFIERS 50з BROADBAND DC to 8 GHz

manufacturer:
Manufacturer
Description:
RF Amplifier IC Cellular, CATV, DBS, PCS, WLAN 0Hz ~ 3GHz
Category:
Amplifier IC Chips
Price:
Negotiation
Payment Method:
T/T, Western Union,PayPal
Specifications
Voltage Range On Any Pin Relative To Ground:
-0.5V To +7.0V
Operating Temperature Range:
0°C To +70°C
Storage Temperature Range:
-55°C To +125°C
Soldering Temperature (DIP, Leads):
..+260°C For 10 Seconds
Soldering Temperature:
See JPC/JEDEC Standard J-STD-020
Highlight:

diode rectifier circuit

,

signal schottky diode

Introduction

MONOLITHIC AMPLIFIERS


features

► low thermal resistance 

►miniature microwave amplifier 

►frequency range, DC to 8 GHz, usable to 10 GHz 

►up to 18.4 dBm typ. (16.5 dBm min) output power

 

 

absolute maximum ratings operating temperature:

-45°C to 85°C storage temperature: -65° to 150°C

 

NOTES:

Aqueous washable

* at 1 GHz for ERA-4,5,6, 4SM,4XSM ,5SM,5XSM, 50SM, 51SM, 6SM, 8SM.

** fu is the upper frequency limit for each model as shown in the table; for ERA-8SM VSWR (In & Out) is specified at DC-1GHz & 1-4 GHz.

 

*** Gain and VSWR are specified at 1.5 GHz. Low frequency cutoff determined by external coupling capacitors.

 

A. Environmental specifications and re-flow soldering information available in General Information Section.

 

B. Units are non-hermetic unless otherwise noted. For details on case dimensions & finishes see “Case Styles & Outline Drawings”.

 

C. Prices and Specifications subject to change without notice.

 

D. For Quality Control Procedures see Table of Contents, Section 0, "Mini-Circuits Guarantees Quality" article.

 

For Environmental Specifications see Amplifier Selection Guide.

1. Model number designated by alphanumeric code marking.

2. ERA-SM models available on tape and reel.

3. Permanent damage may occur if any of these limits are exceeded. These ratings are not intended for continuous normal operation.

4. Supply voltage must be connected to pin 3 through a bias resistor in order to prevent damage. See "Biasing MMIC Amplifiers" in minicircuits.com/ application.html. Reliability predictions are applicable at specified current & normal operating conditions.

 

 

low power, up to +13.5 dBm output all specifications at 25°C

 

Send RFQ
Stock:
MOQ:
20pcs