8 Pin Programmable IC Chips AT89S52-24PU Microcontroller with 8K Bytes
programming ic chips
,ic programmer circuit
8 Pin Programmable IC Chips AT89S52-24PU Microcontroller with 8K Bytes
AT89S52-24PU 8-bit Microcontroller with 8K Bytes In-System Programmable Flash
Features
• Compatible with MCS®-51Products
• 8K Bytes of In-System Programmable (ISP) Flash Memory – Endurance: 1000 Write/Erase Cycles
• 4.0V to 5.5V Operating Range
• Fully Static Operation: 0 Hz to 33 MHz
• Three-level Program Memory Lock
• 256 x 8-bit Internal RAM
• 32 Programmable I/O Lines
• Three 16-bit Timer/Counters
• Eight Interrupt Sources
• Full Duplex UART Serial Channel
• Low-power Idle and Power-down Modes
• Interrupt Recovery from Power-down Mode
• Watchdog Timer
• Dual Data Pointer
• Power-off Flag
• Fast Programming Time
• Flexible ISP Programming (Byte and Page Mode)
• Green (Pb/Halide-free) Packaging Option
1. Description
The AT89S52 is a low-power, high-performance CMOS 8-bit microcontroller with 8K bytes of in-system programmable Flash memory. The device is manufactured using Atmel’s high-density nonvolatile memory technology and is compatible with the industry-standard 80C51 instruction set and pinout. The on-chip Flash allows the program memory to be reprogrammed in-system or by a conventional nonvolatile memory programmer. By combining a versatile 8-bit CPU with in-system programmable Flash on a monolithic chip, the Atmel AT89S52 is a powerful microcontroller which provides a highly-flexible and cost-effective solution to many embedded control applications. The AT89S52 provides the following standard features: 8K bytes of Flash, 256 bytes of RAM, 32 I/O lines, Watchdog timer, two data pointers, three 16-bit timer/counters, a six-vector two-level interrupt architecture, a full duplex serial port, on-chip oscillator, and clock circuitry. In addition, the AT89S52 is designed with static logic for operation down to zero frequency and supports two software selectable power saving modes. The Idle Mode stops the CPU while allowing the RAM, timer/counters, serial port, and interrupt system to continue functioning. The Power-down mode saves the RAM contents but freezes the oscillator, disabling all other chip functions until the next interrupt or hardware reset.
Port Pin | Alternate Functions |
P1.0 | T2 (external count input to Timer/Counter 2), clock-out |
P1.1 | T2EX (Timer/Counter 2 capture/reload trigger and direction control) |
P1.5 | MOSI (used for In-System Programming) |
P1.6 | MISO (used for In-System Programming) |
P1.7 | SCK (used for In-System Programming) |
Program Memory If the EA pin is connected to GND, all program fetches are directed to external memory. On the AT89S52, if EA is connected to VCC, program fetches to addresses 0000H through 1FFFH are directed to internal memory and fetches to addresses 2000H through FFFFH are to external memory.
Data Memory The AT89S52 implements 256 bytes of on-chip RAM. The upper 128 bytes occupy a parallel address space to the Special Function Registers. This means that the upper 128 bytes have the same addresses as the SFR space but are physically separate from SFR space. When an instruction accesses an internal location above address 7FH, the address mode used in the instruction specifies whether the CPU accesses the upper 128 bytes of RAM or the SFR space. Instructions which use direct addressing access the SFR space. For example, the following direct addressing instruction accesses the SFR at location 0A0H (which is P2). MOV 0A0H, #data Instructions that use indirect addressing access the upper 128 bytes of RAM. For example, the following indirect addressing instruction, where R0 contains 0A0H, accesses the data byte at address 0A0H, rather than P2 (whose address is 0A0H). MOV @R0, #data Note that stack operations are examples of indirect addressing, so the upper 128 bytes of data RAM are available as stack space.
TQFP-100 16Bit Flash Microcontrollers Graphics Controller PIC24FJ256DA210-IPT
Original New IC Chips Electronic Components ATMEGA128A-AUR TQFP-64 16MHz Speed
14 20Pin SOIC-14 NanoWatt XLP Flash Microcontrollers PIC16F1825-I/SL
PIC12F675-I/P 8 Pin Flash Based 5.5V 8 Bit CMOS Microcontrollers
AT89C2051-24PU Electronic IC Chip NEW AND ORIGINAL STOCK
ATMEGA8-16AU Electronic IC Chip NEW AND ORIGINAL STOCK
ATMEGA8515-16JU Electronic IC Chip NEW AND ORIGINAL STOCK
ATMEGA8535-16PU Electronic IC Chip NEW AND ORIGINAL STOCK
ATMEGA2560-16AU Electronic IC Chip NEW AND ORIGINAL STOCK
ATMEGA2561-16AU Electronic IC Chip NEW AND ORIGINAL STOCK
Image | Part # | Description | |
---|---|---|---|
TQFP-100 16Bit Flash Microcontrollers Graphics Controller PIC24FJ256DA210-IPT |
PIC PIC® 24F Microcontroller IC 16-Bit 32MHz 256KB (85.5K x 24) FLASH 100-TQFP (12x12)
|
||
Original New IC Chips Electronic Components ATMEGA128A-AUR TQFP-64 16MHz Speed |
AVR AVR® ATmega Microcontroller IC 8-Bit 16MHz 128KB (64K x 16) FLASH 64-TQFP (14x14)
|
||
14 20Pin SOIC-14 NanoWatt XLP Flash Microcontrollers PIC16F1825-I/SL |
PIC PIC® XLP™ mTouch™ 16F Microcontroller IC 8-Bit 32MHz 14KB (8K x 14) FLASH 14-SOIC
|
||
PIC12F675-I/P 8 Pin Flash Based 5.5V 8 Bit CMOS Microcontrollers |
PIC PIC® 12F Microcontroller IC 8-Bit 20MHz 1.75KB (1K x 14) FLASH 8-PDIP
|
||
AT89C2051-24PU Electronic IC Chip NEW AND ORIGINAL STOCK |
8051 89C Microcontroller IC 8-Bit 24MHz 2KB (2K x 8) FLASH 20-PDIP
|
||
ATMEGA8-16AU Electronic IC Chip NEW AND ORIGINAL STOCK |
AVR AVR® ATmega Microcontroller IC 8-Bit 16MHz 8KB (4K x 16) FLASH 32-TQFP (7x7)
|
||
ATMEGA8515-16JU Electronic IC Chip NEW AND ORIGINAL STOCK |
AVR AVR® ATmega Microcontroller IC 8-Bit 16MHz 8KB (4K x 16) FLASH 44-PLCC (16.6x16.6)
|
||
ATMEGA8535-16PU Electronic IC Chip NEW AND ORIGINAL STOCK |
AVR AVR® ATmega Microcontroller IC 8-Bit 16MHz 8KB (4K x 16) FLASH 40-PDIP
|
||
ATMEGA2560-16AU Electronic IC Chip NEW AND ORIGINAL STOCK |
AVR AVR® ATmega Microcontroller IC 8-Bit 16MHz 256KB (128K x 16) FLASH 100-TQFP (14x14)
|
||
ATMEGA2561-16AU Electronic IC Chip NEW AND ORIGINAL STOCK |
AVR AVR® ATmega Microcontroller IC 8-Bit 16MHz 256KB (128K x 16) FLASH 64-TQFP (14x14)
|