Send Message
Home > products > Flash Memory IC Chip > TPS76618DR Power Path Management IC LDO Voltage Regulators 250-mA LDO

TPS76618DR Power Path Management IC LDO Voltage Regulators 250-mA LDO

manufacturer:
Manufacturer
Category:
Flash Memory IC Chip
Price:
Contact us
Payment Method:
Paypal, Western Union, TT
Specifications
Input Voltage MAX:
10 V
Input Voltage MIN:
2.7 V
Output Type:
Fixed
Minimum Operating Temperature:
- 40 C
Maximum Operating Temperature:
+ 125 C
Dropout Voltage:
140 MV
Highlight:

battery charge management ic

,

power management integrated circuit

Introduction

TPS76618DR Power Path Management IC LDO Voltage Regulators 250-mA LDO

 

FEATURES

  • 250-mA Low Dropout Voltage Regulator
  • Available in 1.5 V, 1.8 V, 2.5 V, 2.7 V, 2.8 V,
    3.0 V, 3.3 V, 5.0 V Fixed Output and Adjustable Versions

  • Dropout Voltage to 140 mV (Typ) at 250 mA (TPS76650)

  • Ultralow 35-μA Typical Quiescent Current

  • 3% Tolerance Over Specified Conditions for

    Fixed Output Versions

  • Open-Drain Power Good

  • 8-Pin SOIC Package

  • Thermal Shutdown Protection

     

DESCRIPTION

This device is designed to have an ultralow quiescent current and be stable with a 4.7-μF capacitor. This combination provides high performance at a reasonable cost.

Because the PMOS device behaves as a low-value resistor, the dropout voltage is very low (typically 230 mV at an output current of 250 mA for the TPS76650) and is directly proportional to the output current. Additionally, since the PMOS pass element is a voltage-driven device, the quiescent current is very low and independent of output loading (typically 35 μA over the full range of output current, 0 mA to 250 mA). These two key specifications yield a significant improvement in operating life for battery-powered systems. This LDO family also features a sleep mode; applying a TTL high signal to EN (enable) shuts down the regulator, reducing the quiescent current to less than 1 μA (typ).

Power good (PG) is an active high output that can be used to implement a power-on reset or a low-battery indicator.

The TPS766xx is offered in 1.5 V, 1.8 V, 2.5 V, 2.7 V, 2.8 V, 3.0 V, 3.3 V and 5.0 V fixed voltage versions and in an adjustable version (programmable over the range of 1.25 V to 5.5 V). Output voltage tolerance is specified as a maximum of 3% over line, load, and temperature ranges. The TPS766xx family is available in an 8-pin SOIC package.

Related Products
Image Part # Description
W25N01GVZEIG SLC Nand Flash Memory IC 3V 1G BIT Winbond TW SPI

W25N01GVZEIG SLC Nand Flash Memory IC 3V 1G BIT Winbond TW SPI

FLASH - NAND (SLC) Memory IC 1Gbit SPI - Quad I/O 104 MHz 7 ns 8-WSON (8x6)
PF48F4400P0VBQEK NEW AND ORIGINAL STOCK

PF48F4400P0VBQEK NEW AND ORIGINAL STOCK

FLASH - NOR (MLC) Memory IC 512Mbit CFI 52 MHz 110 ns 64-LBGA (11x13)
DSPIC30F3011-30I/PT Flash Memory IC NEW AND ORIGINAL STOCK

DSPIC30F3011-30I/PT Flash Memory IC NEW AND ORIGINAL STOCK

dsPIC dsPIC™ 30F Microcontroller IC 16-Bit 30 MIPs 24KB (8K x 24) FLASH 44-TQFP (10x10)
IR2110PBF NEW AND ORIGINAL STOCK

IR2110PBF NEW AND ORIGINAL STOCK

Half-Bridge Gate Driver IC Non-Inverting 14-DIP
S25FL032P0XMFI010 SOP8 104MHz Flash Memory IC Chip

S25FL032P0XMFI010 SOP8 104MHz Flash Memory IC Chip

FLASH - NOR Memory IC 32Mbit SPI - Quad I/O 104 MHz 8-SOIC
W25Q80DVSNIG Serial Flash Chip 3V 8M BIT Dual Quad Spi Memory Integrated Circuit

W25Q80DVSNIG Serial Flash Chip 3V 8M BIT Dual Quad Spi Memory Integrated Circuit

FLASH - NOR Memory IC 8Mbit SPI - Quad I/O 104 MHz 8-SOIC
MOS Tube Field Effect Single-Chip Drive PWM Controlador Module IRF520

MOS Tube Field Effect Single-Chip Drive PWM Controlador Module IRF520

N-Channel 100 V 9.2A (Tc) 60W (Tc) Through Hole TO-220AB
MAX485, RS485 Module TTL To RS-485 Module TTL To 485

MAX485, RS485 Module TTL To RS-485 Module TTL To 485

1/1 Transceiver Half RS422, RS485 8-uMAX/uSOP
SKY65336-11 NEW AND ORIGINAL STOCK

SKY65336-11 NEW AND ORIGINAL STOCK

RF Front End 2.4GHz ISM 28-MCM (8x8)
Send RFQ
Stock:
MOQ:
Contact us