TPS2511DGNR Ethernet Switch IC Power Distribution Charging Port Cntrlr & Crnt Ltd Pwr Sw
ethernet transceiver ic
,fast ethernet switch chip
TPS2511DGNR Ethernet Switch IC Power Distribution Charging Port Cntrlr & Crnt Ltd Pwr Sw
1 Features
- Supports a USB DCP Shorting D+ Line to D– Line
-
Supports a USB DCP Applying 2 V on D+ Line and 2.7 V on D– Line (or a USB DCP Applying 2.7 V on D+ Line and 2 V on D– Line)
-
Supports a USB DCP Applying 1.2 V on D+ and D– Lines
-
Automatically Switch D+ and D– Lines Connections for an Attached Device
-
Hiccup Mode for Output Short-Circuit Protection
-
Provides CS Pin for USB Cable Compensation
-
Programmable Current Limit (ILIM_SET Pin)
-
Accurate ±10% Current Limit at 2.3 A (Typical)
-
70-mΩ (Typical) High-Side MOSFET
-
Compatible With USB 2.0 and 3.0 Power Switch Requirements
-
Operating Range: 4.5 V to 5.5 V
-
Available in 8-Pin MSOP-PowerPADTM Package
2 Applications
-
Vehicle USB Power Chargers
-
AC-DC Wall Adapter With USB Ports
-
Other USB Chargers
3 Description
The TPS2511 device is a USB-dedicated charging port (DCP) controller and current-limiting power switch. An auto-detect feature monitors USB data line voltage, and automatically provides the correct electrical signatures on the data lines to charge compliant devices among the following dedicated charging schemes:
-
Divider DCP, required to apply 2.7 V and 2 V on the D+ and D– lines respectively or 2 V and 2.7 V on the D+ and D– lines respectively
-
BC1.2 DCP, required to short the D+ line to the D– line
-
1.2VonbothD+andD–lines
The TPS2511 is a 70-mΩ power-distribution switch intended for applications where heavy capacitive loads and short circuits are likely to be encountered. This device also provides hiccup mode when the output (OUT) voltage is less than 3.8 V (typical) or when an overtemperature protection occurs during an overload condition. Accurate and programmable current limit provides flexibility and convenience for applications. The TPS2511 provides a CS pin for USB cable resistance compensation and an EN pin to control the device turnon and turnoff.
Device Information
PART NUMBER | PACKAGE | BODY SIZE (NOM) |
TPS2511 | MSOP-PowerPAD (8) | 3.00 mm × 3.00 mm |

W25N01GVZEIG SLC Nand Flash Memory IC 3V 1G BIT Winbond TW SPI

PF48F4400P0VBQEK NEW AND ORIGINAL STOCK

DSPIC30F3011-30I/PT Flash Memory IC NEW AND ORIGINAL STOCK

IR2110PBF NEW AND ORIGINAL STOCK

S25FL032P0XMFI010 SOP8 104MHz Flash Memory IC Chip

W25Q80DVSNIG Serial Flash Chip 3V 8M BIT Dual Quad Spi Memory Integrated Circuit

MOS Tube Field Effect Single-Chip Drive PWM Controlador Module IRF520

MAX485, RS485 Module TTL To RS-485 Module TTL To 485

SKY65336-11 NEW AND ORIGINAL STOCK
Image | Part # | Description | |
---|---|---|---|
![]() |
W25N01GVZEIG SLC Nand Flash Memory IC 3V 1G BIT Winbond TW SPI |
FLASH - NAND (SLC) Memory IC 1Gbit SPI - Quad I/O 104 MHz 7 ns 8-WSON (8x6)
|
|
![]() |
PF48F4400P0VBQEK NEW AND ORIGINAL STOCK |
FLASH - NOR (MLC) Memory IC 512Mbit CFI 52 MHz 110 ns 64-LBGA (11x13)
|
|
![]() |
DSPIC30F3011-30I/PT Flash Memory IC NEW AND ORIGINAL STOCK |
dsPIC dsPIC™ 30F Microcontroller IC 16-Bit 30 MIPs 24KB (8K x 24) FLASH 44-TQFP (10x10)
|
|
![]() |
IR2110PBF NEW AND ORIGINAL STOCK |
Half-Bridge Gate Driver IC Non-Inverting 14-DIP
|
|
![]() |
S25FL032P0XMFI010 SOP8 104MHz Flash Memory IC Chip |
FLASH - NOR Memory IC 32Mbit SPI - Quad I/O 104 MHz 8-SOIC
|
|
![]() |
W25Q80DVSNIG Serial Flash Chip 3V 8M BIT Dual Quad Spi Memory Integrated Circuit |
FLASH - NOR Memory IC 8Mbit SPI - Quad I/O 104 MHz 8-SOIC
|
|
![]() |
MOS Tube Field Effect Single-Chip Drive PWM Controlador Module IRF520 |
N-Channel 100 V 9.2A (Tc) 60W (Tc) Through Hole TO-220AB
|
|
![]() |
MAX485, RS485 Module TTL To RS-485 Module TTL To 485 |
1/1 Transceiver Half RS422, RS485 8-uMAX/uSOP
|
|
![]() |
SKY65336-11 NEW AND ORIGINAL STOCK |
RF Front End 2.4GHz ISM 28-MCM (8x8)
|